Wyma Pumpkin Brusher

Wyma Pumpkin Brusher

    Wyma Pumpkin Brusher

    Wyma's Pumpkin Brusher uses long bristle brushes to wash soil, clods, and light scale from pumpkins and squash without skin damage.

    The Pumpkin Brusher reduces manual labor costs and improves the accuracy of grading/sizing equipment. There are two long rows of brushes (on brush shafts) along the length of the machine. Each brush shaft has its own geared motor so each shaft can be controlled individually.

    This means brushing action can be set to suit your needs. One brush shaft is higher than the other so pumpkins are in constant contact with the bristles for a gentle and consistent clean.

    The machine angle can be adjusted to control the speed that produce moves through the Pumpkin Brusher.

    Water spray bars inside the machine rinse produce and also allow chemical application.

    An optional water tank allows waste water to be recycled.

    Features

    • Quickly removes surface dirt from large near-round produce
    • Improves produce appearance
    • Improves accuracy of grading equipment later in the processing line
    • Spray bars rinse produce as it travels through the machine
    • Machine can be adjusted (from 0 - 2°)
    (Click to enlarge)
      Quickly removes surface dirt from large near-round produce Improves produce appearance.
    Improves accuracy of grading equipment later in the processing line.
    A  Fully removable side panels  Access brush shafts and internal structure for easy cleaning and maintenance.
    B  Spray bars  Rinse produce as it travels through the machine.
    Allow chemical application.
    C  Brush shafts at different heights  Produce stays between the brushes and does not get stuck on the sides. This allows a gentle and consistent clean.
    D  Water catchment tray  Collect waste water and allows for water recycling.
    E  Brush shafts controlled by separate geared motors  Run brush shafts at different speeds to fully control brushing action.
    F  Machine can be adjusted (from 0 - 2°)  Change tilt angle to control the speed that produce moves through the machine.
    G Electrical control panel  Makes installation easy and allows total equipment control.
    H  Water tank to collect waste water for recirculation*  Saves water.
       Backing bar*  Stops smaller produce being pulled through the brushes.

    * Optional